In this example I use UFD JOGR older, run communication IC's Alcor AU6981
Run the software for IC communication AlcorMP AU6980/6981 following form (Figure 1)
1. Click the Setup button to set parameters, the login screen will ask for your password, click OK to ignore, the program Setup screen appears (Figure 2).
2. Flash card type
Flash O: You choose a name corresponding to the IC chip on the UFD to your EPP (this is the name of memory chips is controlled by IC communication).
RW cycle time (cycle time of a write / read): you select the desired time, smaller the UFD write / read faster. However, if smaller than the delay time of memory, the write / read will fail.
If you know the parameters of the investigation on the memory chip www.alldatasheet.com to biets RW cycle time of it.
If you do not know can work a few times, changing the cycle time and RW write / read messages, no error is OK.
3. Card Mode (Figure 3)
You can adjust the parameters in the Set Mode:
Common Disl AP: Shared (who is also using the UFD)
Fixed: Using fixed on the machine (to handle it)
Disk readonly: Only read / write is not clear.
Disk Password: Set password.
Auto run: autorun file on it.
CAP set: set the desired size. This allows "fake" capacity. But you know not to do.
Partition set: Set the size for the partition to create, of course, should be 100%. Unless you checked that your UFD error at the end of memory map, then gradually adjust (cut like bad hard drive in PQ)
4. Card Information:
Set information about the manufacturer. If interested, then can his name (without quotes)
Note: You may understand the value to raw VID and PID (I'll talk about this later)
5. Bad card block: For Auto check. Then the software will automatically localize errors in memory chips.
6. Card S / N: Set the serial number for UFD are handled.
After you have done so, OK to return to the main screen (Figure 1)
Click the button to start format LLF low, but larger capacity long.
Once finished, remove the UFD from the computer, plug it back will always run.
Note: If the software does not recognize AlcorMP and memory chip capacity has been damaged, the (hardware) in memory chips. I will talk about this later.
This article I just introduced by software bugs. I wish you success.
If there is any mistake would only help.